Affordable, Easy-to-use, and Versatile!

This battery-powered meter is designed to monitor and store peak readings from torque or force transducers. It is the ideal instrument for the following:

• Monitoring dynamic or static torque applied to threaded fasteners
• Monitoring compression or tension force
• Recording peak values from rotary torque transducers or reaction torque transducers on DC electric or pneumatic tools to evaluate tool performance
• Storing and recalling up to five readings to create statistical control charts

The Model 910 is a single-channel, portable transducer indicator. It has the following features:

• Five peak memories to store and recall the peak or maximum torque or force on five cycles
• Track mode to view the transducer output continuously and during calibration
• Manual span adjustment allows the peak or track readings to be in direct engineering units
• Manual zero adjustment
• Nickel-cadmium rechargeable battery offers eight hours continuous operation before requiring a charge
• Accommodates industry standard transducers with outputs of between 0.8 and 5.0 mV/V
• Calibrates using external shunt calibration resistor
• CW/CCW reversing switch
• Three selectable decimal point positions
• Analog output receptacle for use with chart recorders

Typical Applications

The Model 910 is a versatile measurement tool designed for use on several different applications involving physical measurement: torque, tension, compression, force, strain, and pressure. Below are some typical applications for which the Model 910 can be used in the field.

Power Tool Nutrunners

The Model 910 is specifically designed to operate with RS Technologies rotating socket wrench torque sensors and other reaction torque sensors used to measure dynamic torque applied to a fastener by nutrunners.

Torque Audits
When used with an RS Technologies electronic hand torque wrench you can check the residual torque values on assembled parts.

Torque Wrench Calibration
When used with stationary torque transducers from RS Technologies, the Model 910 displays applied hand torque or click point torque when used with mechanical click wrenches.

Load Cells
The Model 910 is compatible with most strain gage load cells so its can read force in the engineering units of your choice. For instance, the Model 910 can be used with a clamp force load cell (on left) to measure the fastener force generated when a bolt is tighened. It can also be used in combination with a low profile load cell in calibration of a rivet-forming or press operation.

Model 910 Specifications
Instrument Accuracy	±0.5% FS
Non-linearity	±0.25% FS
Temperature Range	0 to 60°C
Battery	8 hour life
Recharger	120 vac, 8-14 hour for complete recharge
Input Sensitivity	350 to 1000 Ohm, full bridge
Input Signal	0.8 to 5.0 mv/v
Display	0.6-inch high LED, 3½-digits, 1999 maximum display
Operating Modes	Peak, Track
Bridge Excitation	10 vdc
Frequency Response	DC to 3.2 kHz
Peak Memory Drift	Less than 1.0% FS in 15 minutes
Calibration	Binding posts for external resistors
Output Jack	0 to 1 volt dc nominal output
Dimensions	9.50" high, 4.20" wide, x 2.75" deep
Weight	1.4 lbs.

Click here for to download the Model 910 Instruction Sheet

Click here to check the transducer input wiring code for the Model 910

Copyright 2007 RS Technologies Ltd., Farmington Hills, MI 48335 USA | Bookmark this site | Contact Us | All rights reserved.